Dometic Fridge Error Codes

Faults are indicated on the display by highlighting the middle section with a red banner and a code. The faults that terminate the complete cooling function are displayed on the screen in combination with a beep.

In case of multiple faults, the last fault is shown on the display. Underlying faults are shown after the last fault is acknowledged.

The beep will last for 2 minutes and repeat every 30 minutes until the fault is restored. Error-type faults must be manually reset by pressing and holding the control knob between 2 s and 4 s. Warning-type faults reset automatically once the condition passes.

Dometic Fridge Error Codes

Error Code 1

 Issue,  NTC fridge compartment defective,  LED Display warning symbol on, all temperature LEDs flashing
Solution Check connection of NTC sensor/ exchange NTC sensor

NTC 2 defective
2 warning symbol on
Currently not in use
E03 : no connection between the display and power module
3
warning symbol on
Check the connection display/power module
W05: AC not available or undervoltage (<190 V)
5 warning symbol on and AC flashing
Connect to AC or choose an alternative energy supply (gas/DC)
W06 : DC not available
6 warning symbol on and DC flashing
Connect to DC or choose an alternative energy supply (gas/AC)

E07: No cooling performance in gas mode
7
warning symbol on
Device stands aslope/ cooling unit defective-> call service
E08: No cooling performance in AC mode
8
warning symbol on
The device stands aslope/ cooling unit or AC heater defective-> call service
E09: No cooling performance in DC mode
9 warning symbols on
The device stands aslope/ cooling unit or DC heater defective-> call service
W10: door open (longer than 2 minutes)
10
warning symbol on and beeping
Shut the door
W11:  Overvoltage DC (>16 VDC)
11
warning symbol on
Reduce DC supply voltage
E12: Daily gas valve test error
12 warning symbol on
No gas mode possible; reset /power cycle; if failure occurs again call service
E13: Dynamic “valve-on” error
13 warning symbol on
No gas mode possible; reset /power cycle; if failure occurs again call service
E50
Gas lockout no ignition after 3 attemps
50
warning symbol on and gas flashing
Failed ignition/gas bottle empty->reset
E51
Gas lockout , internal error on powermodule
51
warning symbol on and gas flashing
Reset; if failure remains, power module needs to be exchanged
E52
short to ground on gas valve
52
warning symbol on
Reset; if failure remains, connection to gas valve to be checked/ power module needs to be exchanged
E53
short to ground on ignition electrode
53
warning symbol on
Reset; if failure remains, connection to the electrode needs to be checked
Tankstop
gas mode is blocked for 15 minutes
gas flashing
gas mode is blocked for 15 minutes, after engine stop-> wait 15 minutes