Bonaire Navigator fault codes:
- Code 1: No flame detected.
- Code 2: Flame detected after lockout.
- Code 3: Thermostat off during flame establishment time or flame establishment time elapsed without flame.
- Code 4: Ignition error.
- Code 5: Flame rollout.
- Code 6: High limit.
- Code 7: Too many high-limit activations in the latest heat cycles.
- Code 8: Communication error.
- Code 9: Board error.
- Code 10: Fan error.
- Code 11: Heat exchanger error.
- Code 12: Timing error.
- Code 13: Pressure switch error.
- Code 14: No gas.
- Code 15: Sensor error.
- Code 17: Power error.
- Code 18: Wiring error.
- No flame detected: This means that the heater is not able to ignite the gas. This could be due to a number of problems, such as a faulty igniter, a dirty flame sensor, or a lack of gas.
- Flame detected after lockout: This means that the heater was able to ignite the gas, but it was shut down due to a safety fault. This could be due to a number of problems, such as a high limit fault, a rollout fault, or a pressure switch fault.
- Thermostat off during flame establishment time or flame establishment time elapsed without flame: This means that the thermostat was turned off before the heater was able to establish a flame. This could be due to a number of problems, such as a faulty thermostat, a dirty flame sensor, or a lack of gas.
- Ignition error: This means that the heater was unable to ignite the gas. This could be due to a number of problems, such as a faulty igniter, a dirty flame sensor, or a lack of gas.
- Flame rollout: This means that the flame from the heater has escaped from the combustion chamber. This is a serious safety hazard and could cause carbon monoxide poisoning. If you see this fault code, you should turn off the heater immediately and call a qualified technician.
If you see one of these error codes on your Bonaire Navigator, it is important to have it repaired by a qualified technician. Ignoring the error code could lead to further damage to your heater.
Here are some additional tips for troubleshooting Bonaire Navigator fault codes:
- Check the gas supply to your heater.
- Make sure the thermostat is set correctly.
- Clean the flame sensor.
- Replace the igniter.
- Inspect the heat exchanger for leaks.
If you have tried these troubleshooting tips and you are still getting an error code, it is time to call a qualified technician.